Bartels-Rausch

Creative Commons Attribution Share-Alike

a-ice-oxygen-k-edge-nexafs-spectroscopy-data-set-on-gas-phase-processing

The Swiss Federal Institute for Forest, Snow and Landscape Research is concerned with the use, development and protection of natural and urban spaces. The focus of their research is on solving problems to do with the responsible use of landscapes and forests and a prudent approach to natural hazards, especially those common in mountainous countries.

swiss-federal-institute-for-forest-snow-and-landscape-research

Swiss Federal Institute for Forest, Snow and Landscape Research

The table lists all NEXAFS raw data with the following columns:

* name:						raw file name
* xRayEkinRange_eV: 		Smallest and largest X-ray photon energy in eV
* scientaPassEnergy_eV: 	Pass energy of electron analyzer in eV
* scientaDwellTime_ms: 		Dwell time of electron analyzer in ms
* regionName:				O K-edge for all data
* scientaAcquisitionMode: 	Fixed energy (snapshot) mode
* scientaEkinRange_eV: 		Smallest and largest energy of the kinetic energy window used for detection in this work
* scientaEkinStep_eV		Not defined in fixed energy mode
* scientaLensMode:			Tune table
* scientaRegionIterations: 	Iterations (sweeps)
* scientaSequenceIterations: Iterations (sweeps)
* sampleTemp_dC: 			Temperature as monitored at the sample holder in °C
* cellPressure_mbar: 		Total pressure in measurement cell in mbar
* iceTemp_dC: 				Temperature of ice sample calculated based on vapour pressure (assuming total pressure equals partial pressure of water) in °C
* smplX_mm: 				positon of measurement spot, x dimension in mm
* smplY_mm: 				positon of measurement spot, y dimension in mm
* smplZ_mm: 				positon of measurement spot, z dimension in mm
* sealingTemp:				temperature at base of sample manipulator
* lastModifiedDatestr: 		time and date when data aquisition was finished
* sample: 					sample description

Near Ambient Pressure partial Auger-Meitner electron yield X-ray absorption spectra and photon flux data. X-ray energy in eV in column 1, analyzer electron count intensity in arb. units in column 2.


Processed data as shown in Figure 4 of publication. X-ray energy in eV in column one, electron count intensity in arb. units in column 2.